Ring Roller MillS for Poison As a clean, efficient, high-level, high-yield of advanced crusher models in the pulverization of Western medicine producers, is very extensive, from a few tens of micro-test test At the time of hundreds of tons of large production, gas flow milling with narrow particle size distribution, average particle size; good powder shape, high product purity; suitable for low melting point, thermistory drug; good sealable, low pollution; Easy to operate; crushing-mixed-dry online operations, etc. have been widely recognized by the company.
Crushing product except for particle size, there is also a narrow particle size distribution, smooth particle surface, particle shape regular, high purity, high activity, good dispersibility. Since Ring Roller Mills for Poison generates a Juromon cooling effect during the crushing process, it is also suitable for ultrafine pulverization of low melting, thermal material. Ring Roller Mills for Poison pulverization process is an important technical parameter and important indicator.
If the gas is too small, the kinetic energy of the airflow will be insufficient, which will affect the fineness of the product. However, if the gas ratio is too high, not only waste energy, but even the dispersion performance of certain particulate materials will also be deteriorated.
When the particle size of the feed is smashed, the particle size of the feed is more stringent. In the case of titanium powder, when pulverizing the calcined material, it is necessary to control 100-200 mesh; the material after the pulverization surface is generally 40-70 mesh, and cannot exceed 2-5 mesh.
Technical parameters:
Finished granularity: 100μm
Production capacity: 500kg
1, when crusher homework, operation The person should stand in the direction of the cutting line of the hammer, and if you don't wear your gloves, your hands must exceed the security line, not allowing iron and sticks instead of hair.
2, pulverizer and power unit should be installed firmly. If the device is fixed for a long time, it should be fixed on the cement; if the deviceIt is a mobile operation, and the unit should be mounted on a base made of angle iron and ensure that the throttle of the power machine (diesel or electric motor) and the equipment of the device are in the same turning plane.
At the same time, check if the leather belt looseness is appropriate.
4 Whether the power machine and the pulverizing machine are lubricated.
5, don't just replace the pulley, prevent the transition chamber to produce explosion, or the speed of the pulverizer is too low.
6. After the pulverizer starts, it should be idled by 2 to 3 minutes, no abnormal phenomenon, then press the work.
7. At any time, pay attention to the operation of the equipment, the feeding should be uniform, to prevent blocking bullies, do not have a long time overload. If there is found that vibration, noise, the bearing and the body temperature is too high, the outer spray, etc., should be closed immediately, and the fault can be eliminated.
8. When blocking occurs, it should be stopped immediately. It is strictly forbidden to use a wooden stick or hand to feed or pull out the feed to avoid the pulverizer to wound the arm or damage the machine.
9. If you crush a hard raw material, the operator must wear glasses.
10, the workplace should have a ventilator and strictly prohibit fireworks to prevent dust explosion from fire.
