Pin Mills of Abrasive's mainly used pulverization mechanism determines the characteristics of high application range, high finished product, widely used in chemical, minerals, metallurgy, abrasives, ceramics, refractories, pharmaceuticals, pesticides, food, health products , New materials and other industries.
Pin Mills of Abrasive has a small size, light weight, high efficiency, no dust, cleaning, easy to operate, and beautiful modeling, etc.
The pulverized groove and the blade are made of stainless steel. It can complete the coarse crushed and fine powder in 3 seconds to 2 minutes. It can quickly crush a variety of Chinese herbal medicines and most of the food, wide and wide, and different properties. It is very well pulverized, and the material is losses, and the dissection of different materials will not be strooked.
such as Western ginseng, ginseng, three seventh, placenta, baui, pearl, white peony, 苡 苡 米, green beans, soy, sesame, rice, corn, etc.
Alpa Pectin PIN MILLS OF Abrasive Case Sharing: Yantai Ephegeral Shares, the company needs to purchase a super-smashing equipment for pulverizing gelatin. Through multi-party investment and incoming experiment, the company purchased our AlPa's PIN Mills of Abrasive as its pectin ultrafine pulverized equipment.
Finished particle size: 60-200 目
Production capacity: 300kg
In the production process, it should be paid to the maintenance and maintenance of PIN MILLS OF ABRASIVE.
1. In the production process, the bearing temperature should be checked regularly. When the temperature rises above 50 degrees Celsius, the machine should be stopped to find the cause and troubleshoot.
3, which should be regularly inspected, replace it in time, ensuring production quality and production.
4, the wear of the blade and lining should be checked regularly. If the productivity is lowered after the wear, the grain size is thicker and the wear is immediately replaced.
5, the host and the hierarchical flow bearing use grease lubrication.
6, the replacement period of the bearing is 2000 hours, the amount of the grease is 1/2 or 3/4 of the bearing cavity space. (Lower test) The temperature of the bearing will be too high.
7, the spiral feeder changes the fat period of 4,000 hours, plus ordinary calcium based grease.
8, in the output shaft E, i.e., pulley E, avoid heavy hush, damage to the part.
9. It is strictly forbidden to turn the handle of the handwheel in the stop.
10, the governor usedThe oil is used to use N32 alkaline high-zinc high anti-milling oil, and the reducer uses 401 universal lubricants and cannot be replaced by other machines.
11. After 3000 hours, the new oil should be replaced, and then used after 500 hours of oil for the second change, then use it after 1000 hours.
The above is a matter of use of Pin Mills of Abrasive, and you can pay more attention to us!
