Vibration Mills for polyacrylate is a crushing equipment commonly used in industrial production. Due to its excellent performance, it is widely used in the crushing operations of various materials. Although the efficiency of this work is very prominent, we still have to look at the machine, just like a normal machine, check the machine, eliminate the machine failure, make the machine more efficient and safely.
What is the design structure of VIBRATION MILLS for polyacrylate?
Under the action of the high-speed rotary impeller, the gas pressure flowing through the impeller increases, and the high pressure airflow flows out of the impeller, the fine particles are ejected. Since the blade of the rotary vane is designed as a bending, the inlet is large, the exit cross-sectional area is small, so the airflow pressure at the outlet is reduced, the speed increases, and the rotational flow is conducive to classification.
The grading point adjustment mechanism sets three adjustment rods and keeps its synchronous motion using the chain. When the adjustment rod moves up, the fine powder increases; when the adjustment rod moves down, the fine powder is reduced. The graded point can be continuously adjusted, and the granularity of the Vibration Mills for polyacrylate can be adjusted. The gradular weight product can reach D97 ≤ 3 ≤ 150 microns, suitable for fine grading of dry micrometer products.
The setting of the control ring is to ensure that the control ring is formed between the control ring and the radial particles ring, and the stability of the airflow flow is controlled. The residual windlet inevitably introduces excess gas from the dry material, the temperature of the classification chamber is high, and the air can expand, and therefore designed a residual tightening to maintain the stability and balance of the graded indoor airflow.
ALPA Soybean Vibration Mills for polyacrylate case share: The customer is a company in the Netherlands. The company needs ultrafine pulverization to soybean meal (after oily oil). Investigating European equipment manufacturers, integrating, or our ALPA equipment is better than the performance ratio, or from cost performance. Through the incoming experiment, the company chose our company's Vibration Mills for Polyacrylate.
Vibration Mills for polyacrylate is widely used, do you know how to use it correctly? The following content hopes to help you.
2, open the machine
(1) Open the compressor power supply, the dust collector pressure valve and the main air valve, open the air pulverizer power switch, and turn on the power switch.
(2) From scratch, gradually adjust to fingerSpeed.
(3) Open the fan, cyclone separator, dust collector, charge motor, open the total power box, set the inverter frequency, and then start charging.
(4) The particle size of the finished product can be adjusted according to the frequency and bearing capacity of the grading wheel.
3, the sequence of stops:
inverter-feeder-main air valve-compressor-grade impeller-motor cyclone material, dust removal switch-fan-main power supply-air compressor .
4, Maintenance
(1) The motor should be lubricated regularly, but the lubricating oil should not excessively avoid the bearing temperature.
(2) Check the wear of impeller, helical conveyors, and crushing nozzles.
(3) After pulverizing the material, the rubber powder should be removed to avoid clogging, thereby affecting the crushing effect.
(4) After the filter bag, it should be cleaned or replaced.
5. Precautions
(1) When the discharge equipment is run, the unloading port cannot be reached, and the accident occurs.
(2) The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller, and the electric chance are damaged.
(3) Regularly check the safety valve to ensure safety.
Shan Dong Alpa is a scientific and technological private enterprise producing various airflow pulverities, airflow mills, disc gap pulverities, disc air crushers.
