Pin MillS OF SORGHUM is well balanced, only need to be produced in a smooth ground place, low noise, can avoid dust leakage during the pulverization process, favored by the powder industry.
The crushing product is in addition to the particle size, and the particle size distribution is narrow, the particle name is smooth, the particle shape is high, and the high activity is high, the dispersibility is good.
ALPA crystal sorbitol Pin MillS OF SORGHUM Case Sharing: Taiwan's cosmetics requires a large amount of production capacity of crystal sorbitol, through our Shandong ALPA agent learned that our company can carry out crushing equipment Customized service. After many incident experiments. In the end, I purchased a Pin Mills of Sorghum.
Technical parameters:
Finished granularity: 10-200 目
Production capacity: 10T
Do you know how to use Pin Mills of Sorghum correctly? I hope the content below can help you.
1. Preparation before the pulverizer is started to check whether the host, joint, pipeline, and the valve are normal and working properly.
2, open the pulverizer
(1) Open the compressor power supply, dustpress pressure valve and the main air valve, open the power switch of the pulverizer, turn on the power switch.
(2) From zero, gradually adjust to the specified speed.
(3) Open the fan, cyclone separator, dust removal and charger power, open the total power box, set the frequency of the inverter, and then start charging.
(4) The particle size of the finished product can be adjusted according to the frequency and bearing capacity of the grading wheel.
3, pulverizer shutdown sequence is: inverter - feeder - main valve compressor - Compressive plane impeller motor - cyclone material, dust removal switch - fan - General power supply air compressor.
4, eddy current pulverizer maintenance and maintenance
(1) Periodically lubricate the eddy current pulverizer, but the lubricating oil should not be too large to prevent too high of the bearing temperature.
(2) Check the wear of impeller, helical conveyors, and crushing nozzles.
(3) After pulverizing the material, the rubber powder should be removed to avoid clogging, thereby affecting the crushing effect.
(4) After the filter bag is filtered, it should be cleaned or replaced.
5, eddy current pulverizer precautions
(1) When the device is running, the unloading port cannot be reached, and the accident occurs.
(2) The rotational speed of the impeller should not exceed the specified requirements, otherwise the temperature is too high, the impeller and the electric chance are damaged.
(3)Check the safety valve regularly to ensure safety.
Users who want to view crusher related information can also log in to our website!
