Modern production not only pursues production and finished product quality, but also develops toward environmental protection. Especially in the comminution industry, the overall development trend of PIN Pulverizer for VC technology in my country is to stabilize the rate, controllability, high quality and other stable development.
PIN PULVERIZER FOR VC is mainly mainly after the material accelerates through the nozzle, and the compressed air enters the flow of the pulverization region, and the material is fluid, each particle has the same motion state. In the pulverized region, the accelerated particles collide with each other in each nozzle. The pulverized material is delivered to the grading area through the upper gas stream, and the fine powder of the particle size is selected by the horizontally arranged grading wheel, and the coarse powder that does not reach the granularity requirement, returns to the pulverization region to continue pulverization. Put the qualified fine powder with the airflow into the high-efficiency swirl separator, and purify the dust gas by the dust collector, discharged into the atmosphere, and the entire pulverization process reaches the high requirements of environmental protection.
ALPA Sodium Pin Pulverizer for VC Case Sharing: This customer is mainly engaged in high energy chemistry, hydrogen production and hydrogen energy development, special gas, fine chemical, environmental engineering, etc. The research institute requires a device that can be superfined with sodium chlorate. Find a domestic powder equipment enterprise. Finally, I purchased a Pin Pulverizer for VC in our AlPa.
Technical parameters:
Finished particle size: 100-325 mesh
Production capacity: 500kg
Temperature rises in the bearing must be checked frequently in the production process, when temperature rise exceeds 50 At ° C, the check is stopped, and the reason is to troubleshoot. When the new machine is running, the drive belt is easy to elongate, pay attention to adjust the proper looseness of the belt to ensure the work life of the belt. If the lifting piece should be checked frequently, replace the production quality and production in time. The blade, the bushing should often check the wear situation. If the wear is worn, the productivity decreases, and the particle size is roughly discovered to be replaced. The host and the grading flow bearing are lipomatic lubrication, using special lipids, the replacement period of the bearing is around three months, and the filling of the grease is 1/2 of the interior space in the bearing cavity. Otherwise, It will cause too high of the bearing temperature. The spiral feeder has changed the lipid period of half a year, and Cape Calcium-based grease. In the output shaft E, ie the pulley E, avoiding the weight of the weight, damage the part. It is strictly forbidden to turn the handle on the stop. The lubricating oil used in this regulator is used with N32 alkaline high-zinc high-grade anti-motor oil pressure oil, and the deceleration machine is 401 generally lubricating oil, and it is not necessary to use other machines. After four or five months, new oil should be replaced.
The company provides free experiments and testing, and provides 24-hour consultation services, welcome to use.
