Turbo Pulverizer of Inorganic Salts is good, only need to be produced in a smooth ground place, and low noise, which can avoid dust leakage during the pulverization process, which is favored by the powder industry.
Turbo Pulverizer of Inorganic Salts has a wide range of pulverized granularities, simple and convenient, but during the pulverization process, there is often a case where the crushing effect is different.
The crushing effect is mainly affected by the following factors:
The temperature and pressure of the gas ratio, the feed particle size, the working fluid, and the pulverization aid. The gas-solid ratio of the pulverizer in crush is an important technical parameter and an important indicator. If the gas is too small, the kinetic energy of the airflow will be insufficient, which will affect the fineness of the product. But if the gas is too high, not only will waste energy, but will even degrade the dispersion performance of certain pigments.
When pulverizing hard materials, there is a stricter requirement for the particle size of the feed. In terms of titanium powder, it is necessary to control 100 to 200 mesh when pulverizing calcination; the material after pulverizing surface is generally 40 to 70 mesh, and cannot exceed 2 to 5 mesh.
So, should you choose how high pressure when crushing? Those skilled, this is mainly dependent on the comminutability and fineness requirements of the material.
ALPA Activated Carbon Turbo Pulverizer Of Inorganic Salts Case Sharing: The customer is a research institute Dalian, which requires ultrafine pulverizing activated carbon during research. Investigate a number of domestic vendors, and finally choose to work with our AlPa, purchased a Turbo Pulverizer of Inorganic Salts.
The privacy of the useful life and quality of Turbo Pulverizer of Inorganic Salts is as follows:
1. The properties of the material. In general, the pulverizer can accommodate all brittle materials, but due to the different material properties, the pulverization performance is also different. Due to the intensity, density, hardness, viscosity, shape and electrical performance of different materials, inevitable The difference in crushing effect is caused, wherein the strength of the material is an important factor, while the material that is too high can also result in a decrease in the life of the gas flow grinding.
2. Use time.
If the crusher is working continuously, it will also affect the service life of gas flow grinding, greatly increasing its failure probability.
I want to know friends with other crusher industry knowledge can also log in to the website. If you have our Turbo Pulverizer of iNorganic Salts is interested in, please feel free to contact us.
