With the continuous advancement of pulverizer technology, Rod Pin Pulverizer for Fertilizer Filler has been familiar with it. Now the most popular crushing equipment is Rod Pin Pulverizer for fertilizer filler. It has a wide variety, available for laboratory, home and factory use. It has a wide range of production, high energy consumption, high automation, and high classification quality.
Rod Pin Pulverizer for fertilizer Filler should be installed in place in the place of the site.
Before working, it is necessary to pick up the processing material, no metal, stone, etc., the hard substances are mixed into the machine, so as not to damage the parts or failures in the machine. Check that each component is firm and reliable before booting. Everything is normal, the side can turn on the power, idle for 1-2 minutes, check whether the operation is normal, everything is normal, it can be pushed.
When operating, the operator cannot leave. Once the sound is abnormal, the power should be disconnected immediately.
When machining raw new friends Chinese medicine crusher, the discharge opening should be tied to the bag. When the pulverizer is in use, if you encounter the power supply voltage, do not use it, so as not to damage the motor. When the power supply voltage is normal, the machine is not easily damaged, and the production efficiency is high.
ALPA precipitation method White Carbon Black Rod Pin Pulverizer for fertilizer Filler case share: This customer is an Egyptian company, from our English official website, we have ultrafine pulverized experience of white carbon black black. There are a number of cooperative customers. Through the incoming experiment and on-site visit. Determine our AlPA strength, and finally purchased Rod Pulverizer for Fertilizer Filler from our company.
1. Prepare before booting the host, attachment machine, pipeline, and valve, whether it is intact, whether it works properly .
Second, open
1. Turn on the compressor power supply, the pressure valve and the main valve of the dust collector, then turn on the power switch of the powder machine, and turn on the power.
2. From the zero start grading wheel and gradually adjust to the specified speed.
3. Several turning wind turbines, cyclone separators discharge, dust removal, feed motor power, and then turn on the total power supply of the tube bar, set the inverter frequency, and then begins to break.
4. The particle size of the finished wheel can pass the hierarchical wheel frequencyAnd the charge is adjusted.
Third, the order of shutdown is: inverter - feeder - Main valve - Compressor - Stepper wheel Motor - Cyclone discharge, dust removal switch - Fan - Total Power - Air Compressor.
4, repair
1. The motor should be lubed regularly, but the grease should not be too large, the bearing temperature is too high.
2. Hierarchical impeller, spiral feeder, crushing nozzle wear should pay attention to check, belt tight and suitable.
3. After a crushing material, after a certain period of time, it is necessary to remove the viscosity of the chalk, so as not to block, thereby affecting the crushing effect.
4. After the filter bag, you should clean or replace it.
V. Note
1. When the discharge device is running, the unloading port cannot be extended to avoid accidents.
2. The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller, and the electric machine are damaged.
3. Regularly check the safety valve to ensure safety.
Welcome everyone chooses Shan Dong Alpa, the company specializes in the production and development and service of Rod Pin Pulverizer for Fertilizer Filler product technology, and the company provides customers with safe and reliable products and services to solve our customers. Have worry.
