Many friends who want to produce industrialized must be unfamiliar with Rod Pin Mill Machine Of Graphite. Rod Pin Mill Machine of Graphite has a very convenient, crushing speed, crushing product quality, is a very useful Crush machine.
ROD PIN MILL MACHINE OF Graphite is a compressed air to radiate into the pulverized zone after the supersonic air flow is accelerated into a supersonic gas stream. Therefore, each particle has the same motion state. Low temperature App ROD PIN MILL MACHINE OF Graphite can operate under supersonic air flow, and the commutation has a minimal dozens of low temperature environment. Do not use liquid nitrogen cooling to implement ultrafine processing, low production cost, and benefit. high. Typical materials are: pigments, resins, sulfur, sulfide sulfide, pesticides, epoxy resins, polytetrafluoroethylene, rubber, and phosphate.
Typical products include soybean, pollen, hawthorn, sodium chloride, Cordyceps, mushrooms, pearl powder, gastric medicine, Nimodi, antibiotics, ginseng, angiographic drugs, Ganoderma lucidum, five times, He Shouwu et al .
Typical products are: garnet, silica, diamond, silicon carbide, white carbon black, diamond, aluminum soil, boron oxide, tungsten carbide, special ceramics, etc.
ALPA Carbon Rod Pin Mill Machine Of Graphite Case Sharing: The company produces superfine and super fine pulveruts in the production of static pressure graphite. After multi-party investigation and experiment, finally selected our AlPA as a cooperative customer, we offer the Rod Pin Mill Machine of Graphite provided to its induction of carbon pulverized particle size, particle size range, yield and other needs.
Technical parameters:
Finished granularity: D65: 200 目
Production capacity: 800-1000kg
The operation process of Rod Pin Mill Machine of Graphite is important, you need to pay attention The following points:
1, check all the lines, electrical components, etc. of the pulverizer, whether it is possible to work. Whether the machine is grounded, so that the housing is powered by electric shock. Whether the machine spindle has a card death, if it should be handled in time. Whether the machine has an abnormal situation during operation, if there is a stop check.
2, check the blade, is tightened, whether the blade gap can reach the specified standard. Crusher is in use,Checking the working room is enough or slidable, if it should be removed in time.
3, after the offset is running, it can begin to start the feed.The pulverizer should stop the feed before stopping.Wait until the machine is completely discharged, it can be stopped.
4, the feed should be uniform, not over, so as not to increase the burden on the machine.The pulverizer cannot be cleaned, maintenance, etc. during operation.
The company has consistently follows the standard management, puts quality in the first production and service policy, providing customers with confidence and weighing airflow crusher products and services.
