Vibration Crusher with FRP

Today's industrial requirements have significantly improved, and thinner powder is conducive to the deep processing of the product, thus makes the product more value. The Vibration Crusher With FRP can effectively improve the level of comminution of materials and greatly improve productivity. The Vibration Crusher With FRP has received much attention, the prospect is also optimistic about many people.

Vibration Crusher with FRP temperature increases, when the temperature of the working fluid is too high, the flow rate of the gas increases. Take air as an example, the critical speed at room temperature is 320 m / sec, when the temperature rises to 480 ° C, the critical speed can be increased to 500 m / sec, that is, the kinetic energy increases by 150%. Therefore, increasing the temperature of the working fluid is conducive to improving pulverization. The pressure of the working fluid is the main parameters of the jet speed, but also the main parameters affecting the fineness of the break. Typically, the higher the pressure of the working fluid, the faster the speed, the greater the kinetic energy.
When titanium powder is pulverized by superheated steam, the vapor pressure is usually 0.8 to 1.7 MPa, and generally pulverized calcined material is high, and the material after pulverized surface can be lower.

ALPA calcium carbonate is shared by Vibration Crusher With FRP case: the customer is a stone powder company, mainly engaged in production and processing of calcium carbonate, magnesium oxide and other products, the company needs to grade carbonate ultrafine powder Separate, grade the product of the required granularity section. After the experiment, as well as the production requirements, our AlPA's host can reach the company's needs, and finally purchased a plurality of graded units of our company.

Welcomes the major calcium carbonate flour manufacturers with powder grading to factory to visit and incurred.

Vibration Crusher with FRP should be maintained and maintained

1. Before using it, check all standard parts for all standard parts, and the belt is not tightened.
2, the spindle operation direction must conform to the direction of the arrow shown on the protective cover, otherwise it will damage the equipment, and may cause human damage.
3, check the electrical appliance is not intact.
4. Check the hardware such as metal-free materials in the equipment crushing room, otherwise it will damage the tool, affect the equipment operation.
5, the material must be checked before crushing, and there is no metal material hard article to be mixed to prevent crash or cause combustion.
6, the oil cup on the device should often be injected into the lubricant to ensure that the equipment is operating normally.
7. Stopping the feeding before the shutdown, if it does not continue to be used, clear the in the machine.
8. Check the tool with the screen on time is damaged. If it is damaged, it should be replaced first.
9, use the timing to have a small smallOscillation, be sure to connect the cover to the handle to avoid accidents.

Welcome everyone to inquire!