Most of the product production and processing of products in the current stage use Cell Grinder with Ceramics to use Cell Grinder with Ceramics, which is one of the very common ways of processing, accompanied by the continuous improvement of scientific productivity, and the technology of grading equipment is replaced. It is also imminent. The performance and internal configuration of the grading device of the airflow must also keep the trend of the era to continue the upgrade of the product.
Cell Grinder with Ceramics works in work, and when the temperature of the working fluid is too high, the flow rate of the gas will increase. Take air as an example, the critical speed at room temperature is 320 m / sec, when the temperature rises to 480 ° C, the critical speed can be increased to 500 m / sec, that is, the kinetic energy increases by 150%. Therefore, increasing the temperature of the working fluid is conducive to improving pulverization. The pressure of the working fluid is the main parameters of the jet speed, but also the main parameters affecting the fineness of the break. Typically, the higher the pressure of the working fluid, the faster the speed, the greater the kinetic energy.
When titanium powder is pulverized by superheated steam, the vapor pressure is usually 0.8 to 1.7 MPa, and generally pulverized calcined material is high, and the material after pulverized surface can be lower.
Technical parameters:
finished particle size: D50 less than 325 mesh
Production capacity: 300kg
1, Chinese medicine shredder should be more smooth and easier to use.
2, before the traditional Chinese grinder work, clean processing materials must be selected. Hard metal, such as metal or stones, can not be mixed into the machine, so as not to damage parts or faults.
3, before the machine is opened, check whether the components of the machine are firm and reliable. Everything is normal, so you can work.
4, turn on the power supply, turn for 1-2 minutes, check whether the operation is normal, normal conditions, can put the material. When the crusher is working, the operator cannot leave. Once the sound is abnormal, the power supply should be disconnected immediately. In the new pulverizer raw material, the exit is fixed with a long bag.
5. When using the pulverizer, if the power supply voltage is too low, do not use it to avoid damage to the motor. The power supply is normal, it is not easy to damage, and the production efficiency is high.
