Ultrafine pulverized machine unique design and lower crushing temperature
Ultrafrupted The unique grading chamber and grading wheel, the particle size of the powder
Uniquely designed grading chamber and variable frequency speed regulatory vertical hierarchy, no need to configure the screen, you can granularize the product at low speed Classification; the circulating feed structure is strictly limited by "large particles" and avoids pulverizing, so the particle size distribution is narrow, the particle size is uniform; the grading wheel is classified, and the powder is difficult to sieve 150 mesh. .
The ultra-microfinator pulverization temperature is lower
Due to avoiding the phenomenon of "overcrushing". The pulverizing chamber does not produce excess heat.
At the same time, the air inlet is provided in the pulverized chamber feed end (which can be connected if necessary).
Due to the presence of the ventilation, the temperature that occurs at the time of pulverization is taken away, and the circulating water sleeve is added to the pulverizing casing to further reduce the temperature of the pulverized production. Fully closed negative pressure, powder does not take any leaks during the pulverization process, no environmental pollution, small noise; rounded design, easy to remove, easy to clean, easy to clean.
How to maintain:
1, during production, often check the temperature rise of the bearing, when the temperature rise exceeds 50 ° C, should be closed, and the reason is to rule out the fault.
2, when the new machine is running, the drive belt is easy to elongate, and should pay attention to adjust the appropriate looseness of the belt to ensure the work life of the belt.
3. If the loss case should be checked frequently, replace the quality and production volume in time.
4, blade, the bushing should often check the wear situation, if wear, the productivity decreases, and the particle size is replaced after the particle size is replaced.
5, the host and the grading flow bearing are lipid lubrication, using 2 special lipids, degrees 265-295.
6, the replacement period of the bearing is 2000 hours, the amount of the grease is filled with 1/2 (epithelial) or 3/4 (lower test) of the space in the bearing cavity, or the 3/4 (lo
wer test) is not too much to fill the grease. Otherwise, the bearing temperature can cause the bearing temperature. Too high.
7, the spiral feeder changes the fat life of 4000 hours, plusOrdinary calcium based grease.
