Shandong ultrafine pulverizer manufacturers For common Chinese herbal medicine special ultrafine pulverizer
Shandong ultrafine pulverizer manufacturers For common Chinese herbal medicine-specific ultrafine pulverizer instructions
A, basic operation
1, first ensure that the pulverizer has no debris.
2, place the hopper on the pulverizer, and then put the feed on the hopper and secure it with a lock bolt.
3, the cloth bag is on the outlet, the bag is strictly sandy.
4, turn on the power when it is prepared to be correct.
5, put the material evenly in the feed port, and pay attention to the current table indicator must not be greater than 10A to prevent the current excessive motor speed reduction affects the pulverization effect.
6, after the feeding, please wait for two minutes to completely crush the material, when the power is turned off, and the motor is completely stopped.
7. After turning off the power, pull out the power outlet. 8. After opening the upper cover, clean the bag, hopping.
B. When the blade is used
1. When replacing the blade or installs the blade, please pay attention to the blade direction.
2, inserted into the cross screw hole in the puller chamber with a cross screw knife, and use the plate glove to turn the nut in the lock nut in the lock nut. Release the nut to replace the blade.
C, encounter problems during the pulverization process, improvement mode
1, the crushing requires that the material is dry, especially the viscous material is more dry. The crushing effect is remarkable. Do not excessively less than 10 mm to prevent the card pulverity.
2, pearls and other requirements fineness, please brush the net. When there is a particulate phenomenon in the powder, it is adjusted to achieve the purpose.
3, please pay attention to the internal drug in the hopperExcessive, too much, please first get out after it.
4, during the working process, please pat your bag normally, to ensure smooth air, if the air is not smooth, resulting in the temperature of the airflow pulverizer. Damage to machine components.
5, when pulverization, the drug is too much, the protector jumps out, the motor stops, indicating that the load is too much, and turn off the power to rest for 10 minutes.
6, press the protector, restart the motor work.
7. After the machine is used, be sure to pull out the power outlet to prevent the collision switch leads to hazards.
D, accessories set, sealed gasket, one cloth bag, cross one, plate hand.
