In the classification operation of industrial production at this stage, the use of Vibration Crusher for Silicon Metal is mainly targeted for the effective crushing of solid particles, and is a commonly used comminution equipment in the ultrafine pulverization process.
Many manufacturers who want to smash the machining process will choose to buy a Vibration Crusher for Silicon Metal, but not all the crushers can apply production and processing, the wrong processing method will make the pulverizer wear speed becomes fast . The mill is wear is too fast, and the inner cavity of the pulverizer of the material should be selected when the material hardness is too large.
The device operates for a long time in a higher crushing pressure, which requires uniformity of cyclical replacement losses.
The product after the crushing products are generally single peaks. If there is a double-peak or multimodal main reason, the pulverization pressure is unstable. The solution is based on the gas supply of gas source equipment to meet the amount of gas required for work, ensuring that the lowest gas supply pressure of the gas is high than the working pressure.
The feed speed is unstable. Solution to check if there is a blockage at the feed valve; the material is not very viscous, uniform liquidity, and the stable control feed speed. A filter cake is formed in the pulverizer chamber. The solution is suspended, and the filter cakes in the crushed chamber will then return to the production.
Welcomes the majority of major manufacturers who have the level of grading of Xia Shi powder to the factory to visit, and collective experiments.
1, check all the lines, electrical components, etc. of the pulverizer, whether it can work properly. Whether the machine is grounded, so that the housing is powered by electric shock. Whether the machine spindle has a card death, if it should be handled in time. Whether the machine has an abnormal situation during operation, if there is a stop check.
2, check the blade, is tightened, whether the blade gap can reach the specified standard. Before using the pulverizer, check the working room is enough or slidable, if it should be removed in time.
3, after the offset is running, it can begin to start the feed. The pulverizer should stop the feed before stopping. Wait until the machine is completely discharged, it can be stopped.
4, the feed should be uniform, not over, so as not to increase the burden on the machine. The pulverizer cannot be cleaned, maintenance, etc. during operation.
