It is well known that this product technology in Cell Grinder of Choline Chloride has received extensive attention from the industry.
Cell Grinder of Choline chloride work is also a factor affecting work efficiency. When the temperature of the working fluid is too high, the flow rate of the gas will increase. Take air as an example, the critical speed at room temperature is 320 m / sec, when the temperature rises to 480 ° C, the critical speed can be increased to 500 m / sec, that is, the kinetic energy increases by 150%. Therefore, increasing the temperature of the working fluid is conducive to improving pulverization. The pressure of the working fluid is the main parameters of the jet speed, but also the main parameters affecting the fineness of the break. Typically, the higher the pressure of the working fluid, the faster the speed, the greater the kinetic energy. When the titanium powder is pulverized by superheated steam, the vapor pressure is usually from 0.8 to 1.7 MPa, and generally pulverized calcined material is high, and the material after the pulverized surface is low.
ALPA Buckwheat Powder Cell Grinder of Choline Chloride Case Sharing: A food company is a large joint venture specializing in the production and sales of beverage food.
From the development of a single variety to the production of various products, the products produced are all over the country.
The company has PET filling machine from SASIB, Italy, a PET filling machine, a PET filling machine, Italy SIPA, a PET blower, Italy SIPA, PET blower. The annual production capacity reached 300,000 tons. The company has passed ISO9001 quality system certification, and GMP and HACCP specifications are implemented and certified.
Case parameters:
Product particle size: D50: 3-45UM
Hour yield: 1-5kg
1, when the bearing oil is high, it is necessary to stop checking the cause of the fault and removal immediately.
2, easy to wear parts should pay attention to the degree of wear, pay attention to and do the preparation for replacement of parts.
3, for the top surface of the chassis of the active device, it is necessary to remove dust and other debris avoiding the machine that cannot be broken, the active bearing cannot move on the chassis, causing an accident.
4, all loads of the machine are bearings, so good lubrication and bearings have a large relationship, it can directly affect the service life of the machine and the operating rate, so the amount of lubricating oil required to be injected should be reached. Good seal.
5,The pitching of the wheel will be easily loose, and it must be checked frequently.
6. Note that the operation of each part of the machine is normal.
7. If the rotating gear is in operation, if there is a hitting sound, it should be stopped in time and remove the fault.
