In the classification operation of the industrial production at this stage, the use of Rod Pin Crusher of Cellulose Acetate is mainly for the effective crush of solid particles, and is a crushing equipment that we often use in the product ultrafine pulverization process. .
Rod Pin Crusher's Cellulose acetate is raised in the working fluid, and when the temperature of the working fluid is too high, the flow rate of the gas will increase. Take air as an example, the critical speed at room temperature is 320 m / sec, when the temperature rises to 480 ° C, the critical speed can be increased to 500 m / sec, that is, the kinetic energy increases by 150%. Therefore, increasing the temperature of the working fluid is conducive to improving pulverization. The pressure of the working fluid is the main parameters of the jet speed, but also the main parameters affecting the fineness of the break. Typically, the higher the pressure of the working fluid, the faster the speed, the greater the kinetic energy.
When titanium powder is pulverized by superheated steam, the vapor pressure is usually 0.8 to 1.7 MPa, and generally pulverized calcined material is high, and the material after pulverized surface can be lower.
ALPA pea protein Rod Pin Crusher's Cellulose acetate case share: This customer is a food company in Russia. After finding a lot of powder equipment enterprises, there is no suitable equipment. It has been affected the company's production and operation, and finally I saw the ultra-fine pulverization of pea protein before our website. Finally, through the incoming experiment, I finally determined the Rod Pin Crusher of Cellulose acetate of our company.
Finished granularity: 400 mesh
Production capacity: 1.5T
Rod Pin Crusher's basic requirements
2, pulverizer and power unit should be installed firmly. If the equipment is fixed for a long time, it should be fixed on the cement; if the device is a mobile operation, the unit should be installed on the base made of angle iron, and ensure that the belt wheel groove of the power machine (diesel or electric motor) and the equipment is in the same Rotary plane.
At the same time, check if the leather belt looseness is appropriate.
4 Power machine and pulverizing machine lubricationNo good.
5, don't just replace the pulley, prevent the transition chamber to produce explosion, or the speed of the pulverizer is too low.
6. After the pulverizer starts, it should be idled by 2 to 3 minutes, no abnormal phenomenon, then press the work.
7. At any time, pay attention to the operation of the equipment, the feeding should be uniform, to prevent blocking bullies, do not have a long time overload.If there is found that vibration, noise, the bearing and the body temperature is too high, the outer spray, etc., should be closed immediately, and the fault can be eliminated.
8. When blocking occurs, it should be stopped immediately. It is strictly forbidden to use a wooden stick or hand to feed or pull out the feed to avoid the pulverizer to wound the arm or damage the machine.
9. If you crush a hard raw material, the operator must wear glasses.
10, the workplace should have a ventilator and strictly prohibit fireworks to prevent dust explosion from fire.
Shandong AlPa is a 20-year experience manufacturing company with ROD PIN CRUSHER OF Cellulose Acetate equipment, with a number of patents, welcome to inquire!
