It is well known that Turbo Pulverizer forfermented Wheat This product technology has been widely valued by the industry.
Turbo Pulverizer forfermented Wheat is a high-speed airflow to form a high-speed airflow with multiple relative-arranged nozzles. The crushed material enters the pulverizing chamber with the rising air flow, since the pulverized rotor is high-speed rotation, the particles are subjected to the centrifugal force generated by the pulverized rotor, and the center of heart is generated by the viscous action of the gas flow. When the centrifugal force of the particles is greater than the heart force, that is, the pulverized particle size The coarse particles return to the pulverizing chamber to continue the impact, fine particles flow into the cyclone separator, collectors, and the gas is discharged from the air.
Low temperature without media, ensuring high purity and physical properties of the product. The equipment runs no dust pollution in a negative pressure state. The full use of jet flow can increase the pulverization efficiency of 30% compared to conventional gas flow grinding machines, and the precision is higher.
ALPA equipment is small, and the structure of the pulverizer can be highly machined so fine powder, avoiding the wear of the horizontal crusher pulverized part, and the equipment of the equipment is used under the same material. Multiplier. Small granularity is wide, and the product particle size can be arbitrarily adjusted within 1-74um.
Technical parameters:
finished product particle size: D50 less than 5μm
Production capacity: greater than 50kg / h
1, Crush When the machine operation, the operator should stand in the tangent direction of the hammer rotation, and if you don't wear your gloves, your hand must exceed the security line, not allowing iron and sticks instead of hand feed.
2, pulverizer and power unit should be installed firmly. If the equipment is fixed for a long time, it should be fixed on the cement; if the device is a mobile operation, the unit should be installed on the base made of angle iron, and ensure that the belt wheel groove of the power machine (diesel or electric motor) and the equipment is in the same Rotary plane.
At the same time, check if the leather belt looseness is appropriate.
4, before the pulverizer starts, first turn the rotor, check the jug, hammer andWhether the rotor operation is flexible and reliable, there is no collision in the shell, whether the rotation direction of the rotor is consistent with the direction of the arrow, whether the power machine and the pulverizing machine are lubricated.
5, don't just replace the pulley, prevent the transition chamber to produce explosion, or the speed of the pulverizer is too low.
6. After the pulverizer starts, it should be idled by 2 to 3 minutes, no abnormal phenomenon, then press the work.
7. At any time, pay attention to the operation of the equipment, the feeding should be uniform, to prevent blocking bullies, do not have a long time overload. If there is found that vibration, noise, the bearing and the body temperature is too high, the outer spray, etc., should be closed immediately, and the fault can be eliminated.
8. When blocking occurs, it should be stopped immediately. It is strictly forbidden to use a wooden stick or hand to feed or pull out the feed to avoid the pulverizer to wound the arm or damage the machine.
9. If you crush a hard raw material, the operator must wear glasses.
10, the workplace should have a ventilator and strictly prohibit fireworks to prevent dust explosion from fire.
ALPA also believes that future airflow crushing technologies will become better and better, users who need to purchase such products can contact us.
