Currently, PIN Pulverizer with Copper Lead Powder has gradually entered people's lives, more and more plants, and companies are using the equipment.
PIN Pulverizer with Copper Lead Powder Transformed into a high-pressure airflow for pulverization kinetic energy into a crushing cavity peripheral gas storage, airflow distribution station, airflow pass through the Ravar nozzle accelerated ultrasonic speed air entering the crushing room The material and the inquiry nozzle enters the crushing chamber to synchronize acceleration grinding.
Since the flow cycle of the jet of the crushing chamber and the animal feed, the particles and the particles and the fixed target wall hit, collide, friction, and grind. The fine particles were opened into the center of the pulverizer, and the cyclone separator was entered at the drive of the heart flow, and the coarse powder was thrown into the periphery of the pulverizing chamber, and cycled under the action of centrifugation and continued to be pulverized.
Technical parameters:
Finished particle size: 700 mesh
Production capacity: 800kg
During the production process, the temperature rise of the bearing must often be checked, when the temperature rise exceeds 50 ° C It should be downtime check, and the reason is to troubleshoot. When the new machine is running, the drive belt is easy to elongate, pay attention to adjust the proper looseness of the belt to ensure the work life of the belt. If the lifting piece should be checked frequently, replace the production quality and production in time. The blade, the bushing should often check the wear situation. If the wear is worn, the productivity decreases, and the particle size is roughly discovered to be replaced. The host and the grading flow bearing are lipomatic lubrication, using special lipids, the replacement period of the bearing is around three months, and the filling of the grease is 1/2 of the interior space in the bearing cavity. Otherwise, It will cause too high of the bearing temperature. The spiral feeder has changed the lipid period of half a year, and Cape Calcium-based grease. In the output shaft E, ie the pulley E, avoiding the weight of the weight, damage the part. It is strictly forbidden to turn the handle on the stop. The lubricating oil used in this regulator is used with N32 alkaline high-zinc high-grade anti-motor oil pressure oil, and the deceleration machine is 401 generally lubricating oil, and it is not necessary to use other machines. After four or five months, new oil should be replaced.
