Modern production not only pursues production and finished product quality, but also develops toward environmental protection. Especially in the comminution industry, the overall development trend of Rotor Mill Machine with Iron Oxide Black technology is the stable development of Rotor Mill Machine With Iron Oxide Black technology, high quality, high quality.
The principle of the Rotor Mill Machine with Iron Oxide Black job is to use high-speed airflow to cause the particles of the material itself to collide, and the airflow is hit by the shear effect of the material, the impact of materials and other components and shear, etc. It has caused the material to become more pulverized and the particle size distribution is narrower. Although in certain areas, Rotor Mill Machine With Iron Oxide Black has an irreplaceable advantage, but it also has a shortage of headache, which is relatively high. The principle has passed the precipitation of time and multiple applications, which is more mature, and has been widely used in mineral materials, chemical materials, pharmaceuticals and other industries.ALPA Potassium Permanganate Rotor Mill Machine with Iron Oxide Black Case Sharing: The customer is mainly engaged in the development of high energy chemical energy development. The study needs a device that can make ultraf fine pulverized in high potassium permanganate. Finally, I bought a Rotor Mill Machine with Iron Oxide Black in our AlPa.
Technical parameters:
Finished granularity:
100-325 目
Production capacity: 5kg
1. Prepare before booting the host, attachment machine, pipeline, and valve, whether it is intact, whether it can work properly.
Second, open
1. Turn on the compressor power supply, the pressure valve and the main valve of the dust collector, then turn on the power switch of the powder machine, and turn on the power.
2. From the zero start grading wheel and gradually adjust to the specified speed.
3. Several turning wind turbines, cyclone separators discharge, dust removal, feed motor power, and then turn on the total power supply of the tube bar, set the inverter frequency, and then begins to break.
4. The particle size of the finished wheel can be adjusted by grading wheel frequencies and charging.
3Shrubber.
4, repair
1. The motor should be lubed regularly, but the grease should not be too large, the bearing temperature is too high.
2. Hierarchical impeller, spiral feeder, crushing nozzle wear should pay attention to check, belt tight and suitable.
3. After a crushing material, after a certain period of time, it is necessary to remove the viscosity of the chalk, so as not to block, thereby affecting the crushing effect.
4. After the filter bag, you should clean or replace it.
V. Note
1. When the discharge device is running, the unloading port cannot be extended to avoid accidents.
2. The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller, and the electric machine are damaged.
3. Regularly check the safety valve to ensure safety.
If there is related requirements, please call us!
