With the continuous development of pulverizer technology, Pin Pulverizer With Heavy Calcium Powder has gradually penetrated into daily life.
PIN PULVERIZER WITH Heavy Calcium Powder is transformed into a high-pressure airflow for pulverizing kinetic energy to a crushing cavity peripheral, which is the airflow distribution station. The airflow passes through the Ravar nozzle accelerates supersonic airflow into the pulverizing chamber. The material and the inquiry nozzle enters the crushing chamber to synchronize acceleration grinding.
Since the flow cycle of the jet of the crushing chamber and the animal feed, the particles and the particles and the fixed target wall hit, collide, friction, and grind. The fine particles were opened into the center of the pulverizer, and the cyclone separator was entered at the drive of the heart flow, and the coarse powder was thrown into the periphery of the pulverizing chamber, and cycled under the action of centrifugation and continued to be pulverized.
In the production process, we should pay attention to maintenance and maintenance of PIN Pulverizer with Heavy Calcium Powder.
1. In the production process, the bearing temperature should be checked regularly. When the temperature rises above 50 degrees Celsius, the machine should be stopped to find the cause and troubleshoot.
2, when the new machine is running, the transmission belt is easily elongated. Pay attention to adjust the appropriate tightness of the belt to ensure the life of the belt.
3, which should be regularly inspected, replace it in time, ensuring production quality and production.
4, the wear of the blade and lining should be checked regularly. If the productivity is lowered after the wear, the grain size is thicker and the wear is immediately replaced.
5, the host and the hierarchical flow bearing use grease lubrication.
6, the replacement period of the bearing is 2000 hours, the amount of the grease is 1/2 or 3/4 of the bearing cavity space. (Lower test) The temperature of the bearing will be too high.
7, the spiral feeder changes the fat period of 4,000 hours, plus ordinary calcium based grease.
8, in the output shaft E, i.e., pulley E, avoid heavy hush, damage to the part.
9. It is strictly forbidden to turn the handle of the handwheel in the stop.
10, the lubricant used by the governor adopts N32 baseHigh zinc high anti-mill hydraulic oil, the gear unit adopts 401 universal lubricants, cannot be replaced by other machines.
11. After 3000 hours, the new oil should be replaced, and then used after 500 hours of oil for the second change, then use it after 1000 hours.
The superfine grade machine produced by AlPa can be produced simultaneously for multiple particle size products.Welcome new and old customers to come to consult!
